Go Down

Topic: DUE and Ethernet-Shield works only after a Reset? (Read 611 times) previous topic - next topic

paulinchen

Hello,
i use a DUE with a Ethernet-Shield R3. It works fine.
The DUE is powered over the USB-cable.

But after new connecting the USB-Cable on the programming port of the DUE, the Ethernet will not work. After a Reset of the DUE (open the serial monitor in the IDE or by pushing the reset-button on the Ethernet-shield) it will works fine until power off.

any ideas for a "power on working without reset" ?

Thanks, paulinchen


Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy