Go Down

Topic: Arduino due and pir sensor (Read 1 time) previous topic - next topic

AlexPol95

Hi.. I am a newbie and I am planning a simple school project, I decided to use and already bought the new Arduino Due to use then with PIR sensors. I just read that the new card has a processor working at 3.3 V. .. My question is this, the Arduino supports, manages four PIR sensors that need a 3-5V power supply and release a digital signal of 4V (HIGH) and 0.4 V (LOW), without burning the processor or damage the card ??
This is the sensor: http://www.homotix.it/catalogo/infrarossi/digital-infrared-motion-sensor-s75
Thanks for availability.
AlexPol95

My suggestion:
(I have never used this sensor)


  • Plan to power the sensor with 3.3V instead of 5V.

  • Power the sensor up on the bench with 3.3V, and measure the output voltage range.



If the alarm output max voltage is <= 3.3V, then your good to go.

Chances are, it will be fine, as the digital alarm output voltage is most-likely limited to the excitation voltage of 3.3V.  To be certain, measure it before connecting the alarm output to the DUE.

-Chris

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy