Pages: [1]   Go Down
Author Topic: DUE and Ethernet-Shield works only after a Reset?  (Read 527 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Full Member
Karma: 3
Posts: 112
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

i use a DUE with a Ethernet-Shield R3. It works fine.
The DUE is powered over the USB-cable.

But after new connecting the USB-Cable on the programming port of the DUE, the Ethernet will not work. After a Reset of the DUE (open the serial monitor in the IDE or by pushing the reset-button on the Ethernet-shield) it will works fine until power off.

any ideas for a "power on working without reset" ?

Thanks, paulinchen


Pages: [1]   Go Up
Jump to: