Loading...
« previous topic   next topic »
Pages: [1]   Go Down
Author Topic: Insertiing the motor shield onto the arduino uno  (Read 116 times)
0 Members and 1 Guest are viewing this topic.
suji
Offline Offline
Newbie
*
Karma: 0
Posts: 1
View Profile
« on: March 07, 2013, 08:39:13 am »
 Bigger Bigger Smaller Smaller Reset Reset
Hi, I recently purchased an uno board along with the motor shield(+sensors). However, I have no idea about inserting the shield onto the board  smiley-cry
The pins seem soldered in both the arduino and the shield. i dont see any provision for attaching the shield directly. what is it taht i must do. Kindly help.
Logged

JimboZA
Johannesburg UTC+2
Offline Offline
Edison Member
*
Karma: 34
Posts: 1705
View Profile
« Reply #1 on: March 07, 2013, 08:42:58 am »
 Bigger Bigger Smaller Smaller Reset Reset
Are you sure it's a shield, not a standalone board?

Maybe you should give details of the make and model, and or a photo. Shields are designed to just simply push down into the Arduino holes

Edit... the pix attached show one of my shields 1) approaching the Uno, 2) on the Uno, and 3) pressed home.
« Last Edit: March 07, 2013, 08:56:37 am by JimboZA » Logged
IT Crowd:
Roy... "Have you tried turning it off and on again?"
Moss.. "Have you tried forcing an unexpected reboot?"

Pages: [1]   Go Up
Print
« previous topic   next topic »
 
Jump to: