Pages: [1]   Go Down
Author Topic: Arduino 2560: ISP for ATMEGA2560  (Read 266 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Sr. Member
****
Karma: 2
Posts: 433
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Good Morning,
looking on the web I've see a lots tutorial guide where explain how to our Arduino like in programmer system.

But I didn't found one guide where explain how to burn a new ATMEGA2560 with this method,

is there something to complete that I can have a look kindly ?

Thanks
Gnux
Logged

Offline Offline
Sr. Member
****
Karma: 2
Posts: 433
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi guys any news ?

REgards,
gnux
Logged

0
Offline Offline
Newbie
*
Karma: 0
Posts: 35
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I think the basic principles apply to an atmega 1280 or atmega 2560
if it is a arduino board, it has a icsp connector you can use
if not - look in the datasheet to find out what pins to connecto to 5v, gnd, miso, mosi, clk, and off course reset
and off course connect a crystal

maybe post pictures, more information if the target is a bare ic or a board, will get you some more help ?
Logged

Pages: [1]   Go Up
Jump to: