Go Down

Topic: Arduino 2560: ISP for ATMEGA2560 (Read 337 times) previous topic - next topic

gnusso

Good Morning,
looking on the web I've see a lots tutorial guide where explain how to our Arduino like in programmer system.

But I didn't found one guide where explain how to burn a new ATMEGA2560 with this method,

is there something to complete that I can have a look kindly ?

Thanks
Gnux

gnusso


FigZ

I think the basic principles apply to an atmega 1280 or atmega 2560
if it is a arduino board, it has a icsp connector you can use
if not - look in the datasheet to find out what pins to connecto to 5v, gnd, miso, mosi, clk, and off course reset
and off course connect a crystal

maybe post pictures, more information if the target is a bare ic or a board, will get you some more help ?

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy