Pages: [1]   Go Down
Author Topic: Acoms IC AS-7 Servo  (Read 937 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 10
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Help,

i have just purchased my first Arduino Uno and wanted to test it out with a servo.

i followed the Knob diagram and uploaded the "example" from the library, only to find that the servo went from 0 - 180 degrees and stopped there.

this led me to believe the servo was faulty, so i attached a servo i have modified to run a full 360 and re-ran the program. this time the servo ran in a full circle.

i tried both of these servos with the "sweep" program and the same happened, the wiring has been double checked and all appears to be correct.

what am i doing wrong?

regards and thanks

Martin
Logged

Global Moderator
UK
Offline Offline
Brattain Member
*****
Karma: 290
Posts: 25770
I don't think you connected the grounds, Dave.
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Did you remember:
a) a separate power supply for the servo
b) a common ground between the supply and the Arduino ?
Logged

"Pete, it's a fool looks for logic in the chambers of the human heart." Ulysses Everett McGill.
Do not send technical questions via personal messaging - they will be ignored.

Pages: [1]   Go Up
Jump to: