and i want to know if theres a way to get arduino to apply changes in steps with a loop setup?
Yes, it's possible to use an inverter to generate the high voltage, and control the inverter with the Arduino. What range of voltage is required, and at what current?
OK, that helps.1. Is it the 5V input model, or one of the others?2. Is it being operated close to full load, or nearer to no-load? That affects the maximum input voltage we need to provide.3. What will be the power supply for the system? (I'm interested in whether we have a couple more volts available than the input to the emco device needs.)4. To what resolution do you need to set the output voltage?
When you mean 5V input, do you mean voltage supplied from the arduino?
I have a 10kV generator and a normal 10V generator too.
Havent gotten as far as to decide resolution, a competent resolution should be fine to start off i assume.
Can you give me an example of an RC network model please? Also, are you referring to the actual setup of the system? Am I to assume that an RC network will be connected to an emitter and operational amplifier?
No, I mean the input to the HV power supply. The Q50 is available in versions for 5V, 12V, 15V and 24V input. Have you chosen a particular model in the series, or is it flexible?
What I am asking is, what power supply do you intend to use to power the emco? The Arduino's 5V supply, or maybe some other power supply (such as your 10V power supply) which you may also be using to power the Arduino?
Please enter a valid email to subscribe
We need to confirm your email address.
To complete the subscription, please click the link in the
email we just sent you.
Thank you for subscribing!
via Egeo 16