Pages: [1]   Go Down
Author Topic: Fun Fact for Arduino-based MIDI Monitoring in MIDI-OX  (Read 705 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Karma: 0
Posts: 13
A world without string is chaos.
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi Friends,

So after a fun filled day, I figured out something that must be obvious to everyone.
Unplug your MIDI Out cable before flashing your chip when monitoring in MIDI-OX. Sure, leaving the cable in will yield a quite pretty rainbow pattern on strange midi commands like the purple "PC: Marimba", but every once in a while (often enough to take a major part of your day), the thing will default to a dreaded yellow Song Pattern signal. Your potentiometer information will be trashed and stuck in this crappy color!

You'll be sitting there wondering "what the heck?" It was just working!

Friends don't let friends flash chips with anything plugged in.

Is this common knowledge to everyone else?

Nice, France
Offline Offline
Full Member
Karma: 11
Posts: 237
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

"It is known". Although perhaps not widely. The Rugged Circuits MIDI shield has an option for a MIDI-enable for this reason, so MIDI is disabled during programming. Or, on boards with more than one serial port, use one for programming and a second one for MIDI.

Pages: [1]   Go Up
Jump to: