Go Down

Topic: Help me please (Read 354 times) previous topic - next topic

davisoja

I have an Arduino Uno with a relay shield attached, the relay shield works with digital pin 4 off the arduino. I need help making the Arduino reveive PPM code from a receiver that will tell the pin 4 to go low, only for a very short time. Pin 4 needs to be set to always high until told to go low to activate the relay.

This is for wireless starting of a  remote control lawn mower I am working on for a school project. Any help would be appreciated.



PeterH

If you're using an RC receiver to control the Arduino then it's not really ppm that you're using - it's just servo pwm. The Arduino can send and receive servo PWM signals easily enough. I suggest you look for examples in the playground.
I only provide help via the forum - please do not contact me for private consultancy.

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy