Go Down

Topic: GPS and Arduino (Read 530 times) previous topic - next topic

Venatu

I have a LS20031 GPS module and an Arduino, and want to use the two together.

I have attached both of the GPS ground pins to an arduino ground, and the power to an arduino 3.3 pin, and the rx and tx pins to the 0 and 1 pins.

When I connect it to the computer, the red light on the gps flashes briefly before going out. If I attach a serial monitor, I get no output from the arduino.

Is there anything special you have to do to get serial on pins 1 and 0 to output to usb?

Thanks in advance,

Venatu

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy