Go Down

Topic: Water level controller with a facility to send you a text message if the system (Read 2 times) previous topic - next topic

lipun12ka4

Here I was Building a Water level controller with a facility to send you a text message if the system encounters any error and can be reset manually.I used Aluminium Electrodes as level sensor, their output amplified by  BC547 Transistors and taken into the digital pins of Atmega328, another optocoupler and Relay Driver to drive a 12Volt relay through which the Pump is connected, A buzzer driven by another BC547 NPN transistor and the SeeedStudio SIM900 GSM/GPRS shield to handle GSM Communication i.e. the SMS and "Miss-Calls".
I am attaching the code Herewith, any suggestions or comments are welcome.


Ufoguy

If you want to meet a beautiful nurse you must be patient.

Go Up
 

Quick Reply

With Quick-Reply you can write a post when viewing a topic without loading a new page. You can still use bulletin board code and smileys as you would in a normal post.

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.
Name:
Email:

shortcuts: alt+s submit/post or alt+p preview