Go Down

Topic: Forwarding Call by using AT-Command (Read 102 times) previous topic - next topic


Nov 03, 2015, 07:33 pm Last Edit: Nov 04, 2015, 02:12 pm by erikfx
Hey folks,

i am experimenting with the Arduino GSM-Shield by using AT-Commands via the serial monitor.
My goal is to forward one caller to another one. At first I tried to just use the gsm-library, but there is no function for this.

The Forwarding AT-Command should be this one: AT+CCFC=..

but I can't figure out how to use it correctly. I tried this command after accepting an incoming call: AT+CCFC=1,1,"+4930xxxxxxxx",145;

hope there is an GSM-Expert out there :)

UPDATE: I managed the call-forwarding. Its necessary to choose mode "3" at the 2nd position. That means that the following telephonenumber is going to be registred. Like so:


Unfortunately I can't save the current incomming number, before doing the forwarding process. So is there any workaround for doing the call-forwarding during the incoming call state?

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131