Go Down

Topic: Problem with Arduino UNO (Read 995 times) previous topic - next topic


Hi guys!

I want to show you my problem wondering if you could help me...

I'm working with an Arduino UNO since a few weeks without any problem but since yesterday, I send my sketch to the board but nothing happen. I mean, apparently the program loads well but the arduino doesn't work according to my program (in fact, arduino doesn't do anything).

But the weirdest thing is, that if I load the standardfirmata on the board and I use processing interface to communicate, Arduino start to work.

Someone of you have the answer? I can't control arduino without processing interface...

Thanks for your help guys!!

James C4S

Sounds like a problem with your code.
Capacitor Expert By Day, Enginerd by night.  ||  Personal Blog: www.baldengineer.com  || Electronics Tutorials for Beginners:  www.addohms.com


thanks for your answer but this problem keep happening even with the example codes...


Problem solved!

It looks like I had a trouble with the drivers, because I'm also working with a ZigBee module and I think that was a conflict with the drivers in the COM port.


Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131