Pages: [1]   Go Down
Author Topic: Problem with Arduino UNO  (Read 502 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 3
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi guys!

I want to show you my problem wondering if you could help me...

I'm working with an Arduino UNO since a few weeks without any problem but since yesterday, I send my sketch to the board but nothing happen. I mean, apparently the program loads well but the arduino doesn't work according to my program (in fact, arduino doesn't do anything).

But the weirdest thing is, that if I load the standardfirmata on the board and I use processing interface to communicate, Arduino start to work.

Someone of you have the answer? I can't control arduino without processing interface...

Thanks for your help guys!!
Logged

Fort Lauderdale, FL
Offline Offline
Faraday Member
**
Karma: 71
Posts: 6144
Baldengineer
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Sounds like a problem with your code.
Logged

Capacitor Expert By Day, Enginerd by night.  ||  Personal Blog: www.baldengineer.com  || Electronics Tutorials for Beginners:  www.addohms.c

Offline Offline
Newbie
*
Karma: 0
Posts: 3
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

thanks for your answer but this problem keep happening even with the example codes...
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 3
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Problem solved!

It looks like I had a trouble with the drivers, because I'm also working with a ZigBee module and I think that was a conflict with the drivers in the COM port.

Thanks!
Logged

Pages: [1]   Go Up
Jump to: