Go Down

Topic: Servo problems - makes arduino connect and disconnect over and over (Read 1 time) previous topic - next topic

JimboZA


that pin 13 internal led glows when i am using the servo sweep code even though its not defined in d code...
why is that happening? is that ok?
or is my arduino not working properly?


Seems that's nothing to worry about: there's been a lot of discussion about that here, and iirc the led on 13 being on all the time seems to have snuck in on a certain version. I'm hazy on the details. Mine is on by default, and it annoys the crap out of me, so I just throw a digitalWrite in at the top of each sketch to turn it off.
Roy from ITCrowd: Have you tried turning it off an on again?
I'm on LinkedIn: http://www.linkedin.com/in/jimbrownza

Scamper21

phew! thanks a lot! :)
i feared my arduino was not proper.

Go Up