Go Down

Topic: Adapter for the small 0.05" pitch JTAG connector (Read 997 times) previous topic - next topic


Hi all:

The 10-pin JTAG connector on the Arduino Due has a 0.05" pitch (1.27 mm), which is very small and therefore in my opinion hobbyist unfriendly.

Does anybody know where to source cables or adapter boards in order to bring those pins to a standard 0.1'' pitch (2.54 mm)?

I have heard of an adapter called ARM-JTAG-20-10 at Olimex, but I would like to know if there are alternatives.

A break-out cable like the one in the attached picture would also be nice.


Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131