So, for starters, on post 8; how do I figure out what resistors to use?
I guess with a 5V PWM it maxes at half brightness (Which doesn't seem to make sense to me, PWM is digital, right?
I thought that the data sheet did indicate 10V
Hmm, it's not showing.
cause you can override (With a switch, or modify in line) the arduino's signal with a pot.
but there were enough people saying that it happened to them
I'm going with the PWM drivers for now.
I'm sure a pot between the arduino and the driver would be fine,
Please enter a valid email to subscribe
We need to confirm your email address.
To complete the subscription, please click the link in the
email we just sent you.
Thank you for subscribing!
via Egeo 16