Go Down

Topic: how use motor shield ? (Read 680 times) previous topic - next topic

technobot9482

Hello,

I want to use motor shield, but it don't run...

I use this code :
=============================
int motorM1 = 11;      // LED connectée sur la broche 9

void setup()
{
  pinMode(motorM1, OUTPUT);   // configure la broche en sortie
}

void loop()
{
  analogWrite(motorM1, 512);  // Résultat d'analogRead entre 0 to 1023
}
==========================

Thank you for help !

THX_RoG

in this
void loop()
{
  analogWrite(motorM1, 512);  // Résultat d'analogRead entre 0 to 1023
}
try a val from 0 to 255

and what for motor controller your using
UNO,MEGA2560,MEGA2560
Killed:UNO, MEGA2560, ... More to come

technobot9482

Sorry, I use DC motor. It is on M1.

technobot9482


AlxDroidDev

Can you provide more info on the shield you are using? What model/make is it? What is the main driver in the shield (L293D, perhaps) ?

Is there a library provided by it? If so, there must be an "ENABLE" pin or signal you must send to make the motors turn on.
Learn to live: Live to learn.
Showing off my work: http://arduino.cc/forum/index.php/topic,126197.0.html

technobot9482

Oh, I find this :
http://ladyada.net/make/mshield/index.html
Super !

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy