Go Down

Topic: Reset Pin Move to different pin? (Read 2905 times) previous topic - next topic


I need to use pin 7 for another function, but the GSM shield uses this pin for Modem Reset. I notice that there is a solder bridge so that I can disconnect the reset function from pin 7. What will be the effect on the GSM card if I do this?

Could I change the library to use a different pin and solder a different pin to the modem side of the solder bridge?

Any help would be appreciated.......


Yes, you absolutely can.

Reset pin can be redefined in file GSM3ShieldV1DirectModemProvider.cpp. You'll find a line like this:

#define __RESETPIN__ 7

Change for the pin you prefer (avoid pins 2 and 3) and of course put in place a connection. If it runs OK, please let us know the one you have used, so we can tell other people.

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131