Pages: [1]   Go Down
Author Topic: How to read the Tinkerkit Inputs? Missing docs...  (Read 9031 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 3
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

analogread()?  If so, what are the analog I/O positions that map to these connectors (A0-AX)?

Thanks.
Logged

US
Offline Offline
Full Member
***
Karma: 4
Posts: 183
Electronics are the new Legos
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

This article shows you how to read the Tinkerkit inputs:

http://21stdigitalhome.blogspot.com/2013/03/reading-arduino-esplora-tinkerkit-inputs.html


The IN-A is set to +5V and IN-B set to ground via jumpers

At the end of the article, it gives an overview of the Tinkerkit outputs - they are directly mapped to PWM pins 11 and 3 so they are easier programatically to use.

I hope this helps others use their Esplora in the time before the team releases revised code to officially use these features.

Mike - http://21stdigitalhome.blogspot.com/
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 3
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Thanks, Mike!  Exactly what I needed.
Logged

US
Offline Offline
Full Member
***
Karma: 4
Posts: 183
Electronics are the new Legos
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Glad I could help and I learned a couple of things in the process.
Logged

India- Coimbatore
Offline Offline
Newbie
*
Karma: 0
Posts: 2
Hey
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Thanks budy... was helpful...
Logged

Always a techie...

Pages: [1]   Go Up
Jump to: