Go Down

Topic: How to show internal pullups on a schematic? (Read 2027 times) previous topic - next topic

Grumpy_Mike


If the pin/input has a name you put a bar over the top of it to indicate that the logic is reversed (that it has an internal pullup). Shouldn't that be sufficient?

No a bar means active low, that is a logic zero means the name is true. It is absoloutly nothing to do with pull up resistors.

If you want to show internal pull ups on schematics you draw them inside the outline of the box that represents the IC.

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy