Go Down

Topic: ATMEGA8L - 8PU with UNO R3 (Read 1 time) previous topic - next topic

I have a ATMEGA8L - 8PU with me.
Is it possible to use this with UNO R3 ??
What are the other MCUs that i can use with the UNO R3??

Erdin

Please explain your question.

You can use a ATmega8 16MHz in a Uno board.
You can use a ATmega8L 8MHz in a Uno board if you replace the X-tal with a 8MHz X-tal.
You can use a ATmega8L 8MHz to communicate with an Arduino Leonardo via I2C or serial Rx Tx.
You can use the Arduino Uno to upload a sketch into the ATmega8L.

I wanna reduce my project cost by using cheaper ATMEGA8 MCU.
I already have a ATMEGA8L MCU.
What i'm asking is can i plug this MCU directly into the Arduino UNO board and program it?
If yes, pls explain.
If no, then pls tell what are the MCUs that i can directly plug into the UNO board and burn sketches into.

After burning the sketches i'll pull out the MCU to use it in a proto-board.

Erdin

I can't answer that, there are too many options.

The ATmega8 16MHz is Arduino compatible, if you use an external X-tal of 16MHz.
The ATmega8L 8MHz is not default compatible, but you can add it to the file boards.txt

Do you want to use a X-tal on the proto-board ? Or do you want to run it at the internal clock ?
Using the internal clock is not very accurate and a serial connection can have a slightly different baudrate.

A standalone Arduino compatible setup, http://arduino.cc/en/Main/Standalone
This is Nick Gammon his page about a compatible setup, http://www.gammon.com.au/forum/?id=11637
You can use an Arduino as a programmer, http://arduino.cc/en/Tutorial/ArduinoToBreadboard

fungus


I have a ATMEGA8L - 8PU with me.


The '8' in '8PU' is the maximum clock speed. It won't work in a board with a 16MHz clock.

Better to stick it in a breadboard and do "Arduino as ISP"  http://arduino.cc/en/Tutorial/ArduinoISP
No, I don't answer questions sent in private messages (but I do accept thank-you notes...)

yes guys, i'm going with the "Arduino as ISP" as i already have all the necessary components.

Thanks guys.

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy