Go Down

Topic: Ethernet on 1.0.4? (Read 2 times) previous topic - next topic

Paul Stoffregen

I resolved my problem.  Another experimental library I had installed and even hacked a bit was conflicting with Ethernet.  When I deleted it, Ethernet started working again.

SurferTim

@Paul: Good to hear that.

@sencorp: Try this to test the SPI connection. Does it display the correct ip?
http://arduino.cc/forum/index.php/topic,156082.msg1169948.html#msg1169948

Post a link to your ethernet shield. Is the processor a w5100 or ENC28J60?

sencorp


@Paul: Good to hear that.

@sencorp: Try this to test the SPI connection. Does it display the correct ip?
http://arduino.cc/forum/index.php/topic,156082.msg1169948.html#msg1169948

Post a link to your ethernet shield. Is the processor a w5100 or ENC28J60?



Hey Tim. Thanks for getting back.

  I gave the SPI a try.  The return on the Monitor is :

Starting W5100
0.0.0.0

The processor is a ENC28J60.  (Buggar was hard to read so needed a bit of help. Photo below.  XD)


Paul Stoffregen


The processor is a ENC28J60.


That's not going to work with Arduino's Ethernet library, which is designed for the (very different) W5100 chip!

sencorp



The processor is a ENC28J60.


That's not going to work with Arduino's Ethernet library, which is designed for the (very different) W5100 chip!


So am I correct to believe that at one time it did work, but the new Librarys are now for the W5100? I did find this, http://www.geeetech.com/wiki/index.php/Arduino_ENC28J60_Ethernet_Module  Seems at one time it did work. Although I did try the Library from the link and it just would not take. 

Go Up