Pages: [1]   Go Down
Author Topic: Code is not getting burn in Arduino Uno  (Read 169 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 4
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi,
While burning the code in Arduino board the code does not get burn rather i get this thing...
Avrdude: skt500_getsync(): not in sync: resp=0x00
 help me if someone faced this problem earlier...Thanks
Logged

North Queensland, Australia
Offline Offline
Edison Member
*
Karma: 74
Posts: 2226
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Its been a common question, search the forum for the string "Avrdude: skt500_getsync(): not in sync" and you'll probably find a few things.

To start off with, do you have anything plugged into pins 0 and 1, if so disconnect those or use different pins. If you need a second serial interface, you can search for examples using the SoftwareSerial over different pins.
Logged


Offline Offline
Newbie
*
Karma: 0
Posts: 4
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

The issue is resolved. What i did to resolve the issue was checking weather the arduino board and the communication port is correctly selected or not then i re-extracted the arduino-1.5.6-r2 and the sketch got uploaded 
Logged

Pages: [1]   Go Up
Jump to: