Go Down

Topic: Arduino Due USB 2.0 Communication (Read 515 times) previous topic - next topic

jiblets

Hello everyone,

I am wondering if there is any known support for communicating with the DUE at the full 480Mbps specified in the datasheet? I am trying to send large blocks of data back and forth between matlab (2007b) and the native port on my due. If I send data in block sizes of 32000 bytes then I can achieve speeds of ~270kB/s, which is okay but I would like to utilize the full speed. I believe that this is a problem on the matlab side, so if there is any way of talking to the due at higher speeds (using matlab or other languages, it doesn't matter) I would love to know.

Thanks!

Go Up
 

Quick Reply

With Quick-Reply you can write a post when viewing a topic without loading a new page. You can still use bulletin board code and smileys as you would in a normal post.

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.
Name:
Email:

shortcuts: alt+s submit/post or alt+p preview