Go Down

Topic: Using SIM900 GPRS shield to send sms (Read 1 time) previous topic - next topic

shreniklad

Hi,

I'm using a SIM900 GPRS shield V1.0 in my project. I am following this link to send an SMS using AT commands http://www.seeedstudio.com/wiki/GPRS_Shield_V1.0
I get correct responses for all the AT commands but when I send hex 1A after typing the message, it responds with "ERROR". Kindly help.

Mobd3

I think you can't send Control Z from the Serial Monitor
make it in your code

Serial.println((char)26);
or
Serial.write(0x1A);

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy