Pages: [1]   Go Down
Author Topic: Leonardo Serial Port issue with Windows 8  (Read 587 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 1
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

All,

My Leonardo is having problems with Windows 8 Pro. During upload the serial port changes briefly from Com 12 to Com 11. I observed this behavior repeatedly in the Windows Device Manager. I can reproduce it also on other Windows 8 systems. The Leonardo worked fine with Windows 7 and Windows 8 CTP.

I used the latest drivers!

Strangely the problem does not occur with my Arduino Ethernet.

Does anyone had the same problems?

Michiel

 
Logged

Austin, TX
Offline Offline
God Member
*****
Karma: 12
Posts: 524
carpe diem
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

This is expected behavior with the Leonardo. I am surprised you did not see this behavior with your previous OS.

The Leonardo shows up as two different CDC devices. When the bootloader is running it shows up as a CDC device with a unique device ID and then during normal operation, it shows up as another CDC device with a different device ID.

Windows will see these as two different serial devices and assign a different comm port number to each one.

When uploading to the Leonardo, the IDE will reset the device to initiate the bootloader. That is when you see one of the ports disappear and the other port appear. Once the upload is complete, the sketch will run and switch to the previous port.

It's possible that on your previous systems, you had the same com port number assigned to each CDC device, so that it looked like the same port. However, you still should have seen it briefly disappear and then reappear during the upload.
Logged

Pages: [1]   Go Up
Jump to: