Pages: [1]   Go Down
Author Topic: SAM-BA operation failed on Due  (Read 2456 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Jr. Member
**
Karma: 0
Posts: 54
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi

I started getting this error on sketch upload - then tried another PC and it worked. Then tried the original PC and it worked. Now trying both, and getting the error again on both. Different cable too.

Sometimes it shows some pages loaded. Is my board dud?
Logged

Offline Offline
Jr. Member
**
Karma: 0
Posts: 54
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

And now a sketch uploaded...I can only think the board is faulty.
Logged

Offline Offline
Jr. Member
**
Karma: 0
Posts: 54
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Which makes me wonder why there isn't adequate QA. This is not acceptable.
Logged

Offline Offline
Jr. Member
**
Karma: 0
Posts: 54
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset


The board seemed to get further as it was connected longer ... eventually the full sketch would load (with no hardware changes => the two geniuses).

Now it does not load at all.

Is there an official Due support site?
« Last Edit: May 27, 2013, 02:01:30 pm by Coding Badly » Logged

nr Bundaberg, Australia
Offline Offline
Tesla Member
***
Karma: 121
Posts: 8453
Scattered showers my arse -- Noah, 2348BC.
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Quote
Is there an official Due support site?
This is it, although not that many people have experience with the Due yet I think.

So far it sounds like you've swapped everything except the Due, that points to a flaky board but you need another one to prove it.

______
Rob
Logged

Rob Gray aka the GRAYnomad www.robgray.com

Offline Offline
Jr. Member
**
Karma: 0
Posts: 54
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Thanks Rob- I bought a new board today, no problems with loading. Old board - old problem.

Then I checked the old board under a magnifier - some pins were pushed together (I must have knocked the board at some stage), and there were some minute junk fragments elsewhere. Cleaned it up - now I have two working boards.

Which is not a bad thing...
Logged

nr Bundaberg, Australia
Offline Offline
Tesla Member
***
Karma: 121
Posts: 8453
Scattered showers my arse -- Noah, 2348BC.
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Good to see you got it working.

_____
Rob
Logged

Rob Gray aka the GRAYnomad www.robgray.com

Pages: [1]   Go Up
Jump to: