Pages: [1]   Go Down
Author Topic: Olimex AVR-ISP-MK2 or Atmel AVRISP-MKII  (Read 507 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Full Member
***
Karma: 1
Posts: 103
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi Arduino experts,

I would like to program the Atmega328 using a programmer from Arduino IDE. I am not sure which programmer to buy. Should I buy Olimex AVR-ISP-MK2 or Atmel AVRISP-MKII? MK2 is a clone MKII and uses 10-pin ICSP. Is MKII using 6-pin ICSP? Can Olimex MK2 be used directly from the Arduino IDE?

Thank you.

Logged

Left Coast, CA (USA)
Online Online
Brattain Member
*****
Karma: 331
Posts: 16464
Measurement changes behavior
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I bought one of these last month for $5+ shipping and it works with the arduino IDE fine and the cable has both 10 pin and 6 pin connectors attached, so works with the arduino 6 pin ICSP pins. It has a jumper to allow the programmer to power the target board or chip, or remove the jumper if the target has it's own power source.

http://www.hobbyking.com/hobbyking/store/__21321__USBasp_AVR_Programming_Device_for_ATMEL_proccessors.html

Lefty
Logged

Pages: [1]   Go Up
Jump to: