Go Down

Topic: Wheatstone bridge (Read 397 times) previous topic - next topic

marcos86

hello
I should realize a Wheatstone bridge with its amplifier to be connected to arduino for the thermoresistors
Some of you have any scheme or how to make it able to explain

thanks

Constantin

Review the sites of Analog Devices, Microchip, Linear Technologies for the ADCs they offer - these (16+ bit) ADCs typically include a drawing in the data sheet on how to use these chips with a Wheatstone bridge - especially when you're dealing with very high-resolution ADCs like the LTC2485, for example.

Theoretically, you could also use an op-amp with an Arduino to build a crude wheatstone bridge. However, I wouldn't simply because the resolution of the ADC inside the Arduino isn't that great (about 10 bits).

Go Up
 

Quick Reply

With Quick-Reply you can write a post when viewing a topic without loading a new page. You can still use bulletin board code and smileys as you would in a normal post.

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.
Name:
Email:

shortcuts: alt+s submit/post or alt+p preview