Go Down

Topic: [Help Needed Urgently] Arduino Uno with XM10 to control Fans or Small Lamp (Read 867 times) previous topic - next topic

bingxun

Hi, I'm a student from Singapore. I brought two AM12U appliance module and 1 XM10 adapter from UK Automation and connect up the XM10 RJ11 port to my arduino uno. The examples on this link https://github.com/DougC/arduino-x10 is the code to communicate the arduino with XM10 there was no problem when compiling. I use the AM12U with the house code A to plug into my fan and the XM10 connect to my arduino uno but the fan could not turn on and off. But when i open the serial monitor it shows "On" and "Off" after the delay of 500. I also realize the the XM10 LED is blinking constantly. I'm using 220V - 240V at my country



Please Help

Thank you

Coding Badly


Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy