Go Down

Topic: Anyone dare to port arduino for STM32F4? (Read 1 time) previous topic - next topic


I got few stm board.  STM32F4 and f0.
It is pain in my back to program it. Anyone have port or bootloader to stm chips.
It would be powerfull if i can code arm cortex using arduino.  Pls help. Cuz i am gonna sell my stm to get mega


I am not aware of any ports. The stm32f4 is ARM based just like the Arduino Due, but from a different manufacturer (i.e., not ATMEL). Therefore the SAM3X libraries in Arduino 1.5.x would need to be replaced, which would require a lot of work.

On the other hand, I have been having a lot of luck programming a stm32f4 discovery board using the GNU ARM toolchain (available at https://launchpad.net/gcc-arm-embedded) and the open source stlink software (at https://github.com/texane/stlink) to compile and flash my programs. While this is a bit more work, ST provides a lot of libraries and examples that show how to interact with the board's peripherals (e.g. i2c, spi, etc.). I have this all set up under Mac OS 10.7 but from what I can gather it is much easier to do under windows.


Have you looked at leaflabs.com?

Lots of people there working with that board and part of what is a very similar to Arduino libraries compiled for the F4 board.
Mind you, it is not at the same level as the Arduino.
This... is a hobby.


Hello All,

I know its too late to reply to this thread, but i am replying as some one like me will be looking for the same answere.

Please have a look at;





You do realize that instead of bumping a thread from august of 2013, you might want to take a look at the >120 page thread at the very top of this section dedicated to discussing Arduino on  STM32 platforms...
ATtiny core for 841+1634+828 and x4/x5/x61/x7/x8 series Board Manager:
ATtiny 841/1634/828/88/861/167 breakouts, mosfets, touch sensors and prototyping board in my store http://tindie.com/stores/DrAzzy

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131