Go Down

Topic: If your components don't sit well on the breadboard, try this! (Read 6152 times) previous topic - next topic

May 01, 2013, 11:12 pm Last Edit: May 04, 2013, 12:08 am by nass Reason: 1
I'm now 4/5 of the way through the starter kit and I've noticed that all the circuits have started giving me trouble. Not because the circuit is wrong, but because of component issues - ie the h bridge, potentiometer and buttons not working properly because they won't sit properly in the breadboard. They pop out. Judging from the forum this affects many others as well.

There are some good solutions on this board like soldering headers onto the pins, and I went and bought a solder to do this, but taking a look at the 16 pin H bridge I decided this was a step to far for someone with no soldering experience. It's only after I bought an expensive good breadboard that I realised why these problems are occuring, and found the solution.

As you know the starter kit breadboard is mounted on a wooden platform, with parts that you remove in order to do certain projects. But, when those parts are removed, it removes support for the breadboard that sits on there, so the metal bars that conduct inside the breadboard seem to sag as you use the breadboard in projects, which lowers them. This lowered rail means the component no longer seat properly because the component legs won't reach down to the lowered internal conducting rail anymore.

It's a simple mechanical thing - the wooden cutouts means there's no backing support for support the internal rails, so they sag. Sagged rails means components can't reach and won't seat.

Easy to fix!


  • Turn the whole thing over

  • Push all the bars back up by pushing on the sticky bits that show (because you've removed wooden bits as instructed in the book!)

  • Turn the whole thing back over

  • Now try reseating the components

  • Voila, they should now seat properly again!



Worked for me  :)
Photography nut trying to make the flux capacitor of macro pho

robtillaart

Rob Tillaart

Nederlandse sectie - http://arduino.cc/forum/index.php/board,77.0.html -
(Please do not PM for private consultancy)

#2
May 02, 2013, 08:49 pm Last Edit: Jun 03, 2013, 03:45 pm by nass Reason: 1
Photography nut trying to make the flux capacitor of macro pho

dean_1230

Thanks for the suggestion!  That made a huge difference!

Inserted a metal washer in the round hole to further support  the metal strip
stops the sag.....


Inserted a metal washer in the round hole to further support  the metal strip
stops the sag.....

Shame there's no 'like this post' button here. Great move  :)
Photography nut trying to make the flux capacitor of macro pho

JimboZA



Shame there's no 'like this post' button here. Great move  :)


Well you can give the OP a karma boost.....
"Could you do the egg bacon spam and sausage without the spam then? "

No PMs for help please.
DO NOT power servos from Arduino 5V: give them their own power and connect the grounds.

Go Up