Go Down

Topic: CASIO calculator and Arduino; joining circuits of different Voltage (Read 1 time) previous topic - next topic

RonaldPoFo

Apr 20, 2013, 07:48 pm Last Edit: Apr 22, 2013, 12:29 am by RonaldPoFo Reason: 1
Hello!

I'm trying to hack a CASIO fx-85ES calculator:


I want to use the calculator as a keypad (arduino knows what button you pressed) and display (arduino "presses" a button), using an Arduino Pro Mini (5v).

buttons are pressed by connecting two contact points on the board:

for example: K07 + KI5 = "1" or K01 + KI2 = "4"
I only want to use the following keys: 0-9, +, -, x, :, =, and ")". total of 16 buttons

I plan to:
Connect points using transistors "press buttons". (is there a way the arduino can do this without transistors)
Use pins as input to read buttons pressed. (or more transistors?)

Note: I will only use calculator as INPUT OR OUTPUT never both at once.

Anything I forgot or suggestions? what do you think, could this work? :P

RonaldPoFo

Would I damage the arduino by feeding the contact points on the calculator to it as inputs?
Do I have to join GND like when wiring a Servo????  (1.5v cicuit of the calculator and 6v circuit of the arduino)

Runaway Pancake

It is not clear what you are asking.

You want to use the Arduino as a substitute for the keypad?
OK

And also to read the calculator's keypad (key strokes), when that is used?
"Hello, I must be going..."
"You gotta fight -- for your right -- to party!"
Don't react - Read.
"Who is like unto the beast? who is able to make war with him?"

RonaldPoFo

I WANT:
An arduino Pro Mini 5v to:
-Know when a button on the calculator is pressed.
-Press buttons on the calculator(buy connecting two connection points)

HOW?:
Know when a button is pressed by reading a change in voltage between connection points.
Use transistors to connect two connection points, transistor's base (B) to arduino.

MY PROBLEMS:
Will feeding a cable from the connection points on the calculator to the arduino damage the arduino? or even work?
Can I join two connection points on the calculator using the arduino, not transistors? ( the two connection points have to be wired one to another, NOT to GND or Vcc)


RonaldPoFo

What does this mean:
quad buffer/line driver with 3-state outputs controlled by
the output enable inputs
I tried goggling around but I don't see how it should help?

grendle

it means you can use this chip to have 2 different components that use different voltage talk to eachother, ie 3.3v to 5v. its a buffer between the 2.

RonaldPoFo

Would I damage the Arduino by feeding input and outputs to and from it without any isolation? (transistor, optocoupler)

grendle


RonaldPoFo


Go Up
 

Quick Reply

With Quick-Reply you can write a post when viewing a topic without loading a new page. You can still use bulletin board code and smileys as you would in a normal post.

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.
Name:
Email:

shortcuts: alt+s submit/post or alt+p preview