Go Down

Topic: Bluetooth/microcontroller question (Read 205 times) previous topic - next topic

Hi everyone,
I just recently built a microcontroller using an ATmega328p-pu and I am wanting to interface a JY-MCU bluetooth module into it. I am using a FT232R breakout board along with arduino software to program. So my question is: can I use the arduino software to program the bluetooth module? If not,what should I use? The rest I will try to figure out on my own but do welcome any advice on the interfacing process.
Any help is most appreciated.

Riva

This guy managed to use a BT module to program his Arduino. Also look here and [urlhttp://ame2.asu.edu/staff/kidane/ArdWilessBtProg.pdf]here[/url].
I might seem like an idiot but remember it takes one to know one.
Forum user generally fall into three categories (the good, the bad & the a**hole) what category do you fit in?

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy