Pages: [1]   Go Down
Author Topic: upgrading xbee serie1  (Read 520 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 30
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi everyone ,
please after a long discussion with DIGI about the problem i have with my xbee's serie 1 802.15.5 version 10EC, they answered e as above:

--------------------
In order to perform a firmware upgrade, you need to have VCC, GND, DI, DO, RTS and DTR connected. I believe the Arduino Shields do not connect these lines from the PC to the XBee module. However you will want to verify that with the manufacture of the board in question.  I think you will find that most 3rd party board will generally only connect Data in and Data out in addition to VCC and GND.
-------------------

So anyone could help me with that o.O I didn't understand wthat should i do ?

Thank you.
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 30
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

PS : i'm using arduino uno + arduino xbee shield +xb24.
Logged

Pages: [1]   Go Up
Jump to: