Go Down

Topic: Is there a mistake at "Motor Control v1.1&quo (Read 604 times) previous topic - next topic

fallen

Jan 23, 2006, 04:48 pm Last Edit: Jan 23, 2006, 04:48 pm by fallen Reason: 1
Hi!
I see the "Motor Control v1.1" in the test , and there is a Partlist : http://webzone.k3.mah.se/k3dacu/arduino/shields/motor_control/motor_control_v1_partlist.txt ,I found "IC3   L293E   DIL16  texas  1" , but I found this Data Sheet of L293E (http://www.st.com/stonline/books/pdf/docs/1328.pdf) and L293E is " POWERDIP(16+2+2) " not 16 .

So I buy a "L293D" instead , the Data Sheet of "L293D" : http://www.st.com/stonline/books/pdf/docs/1330.pdf . Is it OK ?  And I want to make sure that is there a mistake at "Motor Control v1.1" or a mistake at "Partlist" , but I see the PCB , it's "DIL16" , could I use "L293D" instead ? Thank you !

mellis

The 293D is right.  The part list is wrong.

fallen

Thank you !
Do you make some "Motor Control v1.1" board?
Is it test well to use?

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy