Pages: [1]   Go Down
Author Topic: Nunchuk Eagle  (Read 1192 times)
0 Members and 1 Guest are viewing this topic.
0
Offline Offline
Full Member
***
Karma: 3
Posts: 118
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hello.
  There was a nunchuk eagle topic started a couple years ago but it was not answered and is now closed.
  I also would like to make a nunchuk adapter in eagle.  I know they are available at sparkfun.
  
  The nunchuk adapter is basically 4 connectors.  2 on the top and 2 on the bottom.
  They are .15 inches apart ( I think) and are about roughly .1 inches wide.
  The top is ground and SCL and the bottom is power and SDA.   I can wire the items in eagle.  But I don't know how to create pads that occupy the same area but on the top is one pad and on the bottom is a different pad.

  Meanwhile...2 days later....I found some helpful links including a schematic that has 2 nunchuk breakouts:

https://sites.google.com/site/buildagadget/nunchuk_usb/hw_elec_nunchuk/nunchuckUSB-v13.sch
https://sites.google.com/site/buildagadget/nunchuk_usb/hw_elec_nunchuk/nunchuckUSB-v13.brd

Schematic and board are referenced here:
https://sites.google.com/site/buildagadget/nunchuk_usb/hw_elec_nunchuk
 
alternate writeup:
http://voidbot.net/wii-addapter.html

alternate writeup:
http://www.instructables.com/id/Wii-Nunchuck-Adapter/  
« Last Edit: May 07, 2013, 09:29:31 pm by Paulware » Logged

0
Offline Offline
Full Member
***
Karma: 3
Posts: 118
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Created this dual nunchuk tindie project: https://www.tindie.com/products/Paulware/dual-nunchuk-shield/
Logged

Pages: [1]   Go Up
Jump to: