Go Down

Topic: how to use "I2C" in Arduino ? (Read 1 time) previous topic - next topic


Hi ! I see the Atmel Atmega8 datasheet http://www.atmel.com/dyn/resources/prod_documents/doc2486.pdf

and there is a "Two-wire Serial" , is it means "I2C" ? how to use this in  Arduino ? is there some commands to use it simple?

and there are many "Interrupts" ,how to get them?

thank you !

David Cuartielles


the "two wire serial" are the pins 0 and 1 on the board. However, you could make it send I2C or other protocols if designed carefully.



Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131