Pages: [1]   Go Down
Author Topic: Writing to SD Card via Ethernet  (Read 606 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 1
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi,

I am new to this forum so I hope I am posting this in the right place. I am stuck on trying to figure out whether or not it would be possible to write to a flat-file stored on an SD card via an ethernet connection if I were to use this ethernet shield (https://www.sparkfun.com/products/9026).

I want to be able to store a few configuration settings in a .txt file (or similar) stored on the SD Card that the Arduino is able to read from, I want to be able to make changes to these settings via a web-interface and in the future maybe some kind of custom software.

Any direction would be appreciated!

Thanks,
Ben
Logged

Idaho, US
Offline Offline
God Member
*****
Karma: 19
Posts: 900
Special User
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Yes, that should be possible.
Logged

Pages: [1]   Go Up
Jump to: