Go Down

Topic: Oscilloscope ((Arduino+Processing) (Read 2011 times) previous topic - next topic



This is my first attempt at an Arduino Oscilloscope with Processing. Still incomplete; but basically does the job of plotting and recording 3 analog signals connected to 3 Arduino inputs. Controlling the H-sweep has been the hardest part of the project for me. It has severe limitations regarding frequency response; but I want it mainly for very low frequency signals, such as temp, relative humidity, pressure, etc. At this point it has 3 simple pots connected as voltage dividers  to the Arduino inputs to vary the voltage and observe the variations. Still a long way to go to finish it; but I can use it already.

here is the video:  http://www.youtube.com/watch?v=14wGzvVhpnc
Perseverance is 90% of the solution. The remaining 10% is more perseverance.


looks very good,

Is there a download available?
Rob Tillaart

Nederlandse sectie - http://arduino.cc/forum/index.php/board,77.0.html -
(Please do not PM for private consultancy)


Thanks. I appreciate your comments.

I'm planning to make it available; but not for now as it is still a bit incomplete and has a few problems. This is a relatively large Processing code.

Thanks again.
Perseverance is 90% of the solution. The remaining 10% is more perseverance.

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131