Go Down

Topic: EM32100 (Read 189 times) previous topic - next topic

SilentAce

Hello Members,

I happen to have a EM32100 LCD Display laying around from an old telephone and would like to make it show digits  with the Arduino. Well i managed to change between the clock and stopwatch and set the clock. However this is fairly easy to do. The link below is the documentation of the display, but i can't figure out where the latch pin is (if any). There is a Serial data input pin for sending bytes and making some tests unfortunately i haven't manage to display anything. If someone could point out where the necessary pins are, and how i can shift them (probably with shiftOut, since i saw some the examples from the Arduino learning).

Here is the link: http://www.datasheetcatalog.org/datasheets/400/238699_DS.pdf

Thanks

Go Up
 

Quick Reply

With Quick-Reply you can write a post when viewing a topic without loading a new page. You can still use bulletin board code and smileys as you would in a normal post.

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.
Name:
Email:

shortcuts: alt+s submit/post or alt+p preview