Go Down

Topic: Galvanometers (Arduino+Processing) (Read 1 time) previous topic - next topic


Hi all:

These are Galvanometers built with Processing to be used with Arduino. The video shows 2 simple potentiometers connected to 2 Arduino analog inputs as voltage dividers for testing. Needle inertia was implemented by a digital low pass filter in the Processing code to smooth out the needle response simulating the D'Arsonval movement. Communication code uses only numbers no strings.

Hope you enjoy.

Here is the video: http://www.youtube.com/watch?v=5PUrhd8CK7g&feature=youtu.be
Perseverance is 90% of the solution. The remaining 10% is more perseverance.

Go Up

Quick Reply

With Quick-Reply you can write a post when viewing a topic without loading a new page. You can still use bulletin board code and smileys as you would in a normal post.

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

shortcuts: alt+s submit/post or alt+p preview