Go Down

Topic: LCD Shield display corrupted when relays used (Read 1 time) previous topic - next topic

NickA

I am using a Mega with an LCD shield to drive 2 relays to turn a variable frequency drive on and off.   If I run the code just driving the relays, the relays work fine, and the LCD displays correctly.   If I connect the CFD to the relays, it starts and stops correctly (relays working fine), but the LCD panel get corrupted in 1 of several ways; e.g. the first line is corrupted with all of the same non alphabetic character, or wht should be displayed on line 2 is overwritten on line 1.   I have tested that there is no direct electrical connection between the input of the relay and the relay switch, so the VFD appears to be electically isolated from the Arduino.

Does anyone have any ideas?

pluggy

Decoupling (or extra decoupling) on the Arduino and snubber diodes on the relays wouldn't go amiss. Relays are extremely noisy in microcontroller environment.  I'd suggest you stick a small electrolytic capacitor of say 10 - 47uF and a ceramic capacitor of 100nF (or two, or three ;) ) across the 5V supply(s)  as close to the ATmega Chip as you can for the decoupling and a 1n4001 or similar diode "back to front" (ie Anode to Gnd) across each relay coil contacts.  
http://pluggy.is-a-geek.com/index.html

NickA

Excellent; the snubber diodes worked like a charm; thanks very much.

Go Up