Initializing SD card...Wiring is correct and a card is present.Card type: SD1Could not find FAT16/FAT32 partition.Make sure you've formatted the card
Initializing SD card...initialization failed. Things to check:* is a card is inserted?* Is your wiring correct?* did you change the chipSelect pin to match your shield or module?
Description: (We only provide high qulity products,please choose us.)1.Brand new and high quality.2.SD Card module can make your SD application more easier and simple.3.It is easily interfaced as a peripheral to your arduino sensor shield module.4.Through programming, you can read and write to the SD card using your arduino.5.Can be used for SD Card more eaisly, such as for MP3 Player, MCU/ARM system control.6.All SD SPI pins output, MOSI, SCK, MISO and CS.7.Support 5V/3.3V input.8.Size:5.1cm x 3.1cm - 2.01inch x 1.22inc
I have one of those, and it works fine with 5V supply and 5V on the signal lines.
QuoteI have one of those, and it works fine with 5V supply and 5V on the signal lines.The LC Studio modules do work with some SD cards. I have checked several cases where cards work. The card draws a lot of current on the 5V signal lines which may not good for the card or the Arduino The Arduino can only supply enough current to reach about 4 V on the signal lines.The card input lines should not draw current so I think the excess current is due to input protection devices in the card.Not a desirable condition.
Please enter a valid email to subscribe
We need to confirm your email address.
To complete the subscription, please click the link in the
email we just sent you.
Thank you for subscribing!
via Egeo 16