Go Down

Topic: how to control 15 motors 0f 10A 12v motors (Read 2170 times) previous topic - next topic

sonnyyu

#15
Jun 17, 2013, 08:06 pm Last Edit: Jun 17, 2013, 08:07 pm by sonnyyu Reason: 1
I will use low Ron  power mosfet from Philip/NXP Semiconductors.

PSMN0R9-25YLC


  • Current - Continuous: 100A

  • Vdss: 25V

  • Ron: 0.99 mOhm @ 25A, 10V



digikey, $1.49/1pc, $103.95/100pcs

http://www.nxp.com/documents/data_sheet/PSMN0R9-25YLC.pdf



It has very small foot print.

regarding about mosfet gate driver IC, MarkT has good thread

http://forum.arduino.cc/index.php/topic,171389.0.html

johnwasser

I'm not sure but I think the intersil ISL83204A can drive four N-channel MOSFETS in a Full Bridge configuration.

http://www.intersil.com/en/products/power-management/mosfet-drivers/half--full-bridge-and-three-phase-drivers/ISL83204A.html
Send Bitcoin tips to: 1L3CTDoTgrXNA5WyF77uWqt4gUdye9mezN
Send Litecoin tips to : LVtpaq6JgJAZwvnVq3ftVeHafWkcpmuR1e

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy