Pages: 1 [2]   Go Down
Author Topic: how to control 15 motors 0f 10A 12v motors  (Read 1668 times)
0 Members and 1 Guest are viewing this topic.
Earth
Offline Offline
Edison Member
*
Karma: 52
Posts: 1809
My browser no longer is binding static IP, Floating is the way to go.
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I will use low Ron  power mosfet from Philip/NXP Semiconductors.

PSMN0R9-25YLC

  • Current - Continuous: 100A
  • Vdss: 25V
  • Ron: 0.99 mOhm @ 25A, 10V

digikey, $1.49/1pc, $103.95/100pcs

http://www.nxp.com/documents/data_sheet/PSMN0R9-25YLC.pdf



It has very small foot print.

regarding about mosfet gate driver IC, MarkT has good thread

http://forum.arduino.cc/index.php/topic,171389.0.html
« Last Edit: June 17, 2013, 01:07:46 pm by sonnyyu » Logged

Massachusetts, USA
Offline Offline
Tesla Member
***
Karma: 208
Posts: 8856
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I'm not sure but I think the intersil ISL83204A can drive four N-channel MOSFETS in a Full Bridge configuration.

http://www.intersil.com/en/products/power-management/mosfet-drivers/half--full-bridge-and-three-phase-drivers/ISL83204A.html
Logged

Send Bitcoin tips to: 1L3CTDoTgrXNA5WyF77uWqt4gUdye9mezN
Send Litecoin tips to : LVtpaq6JgJAZwvnVq3ftVeHafWkcpmuR1e

Pages: 1 [2]   Go Up
Jump to: