Go Down

Topic: Connect Colorduino with uartsbee (Read 633 times) previous topic - next topic

putskiz

Hello all,

I'm trying to connect my colorduino v1.3 with a uartsbee v4.0 but I can't manage to get to right wiring.

On the Colorduino side I have the following outputs :

DTR
GND
TXD
RXD
VDD
GND
SCL
SDA

and on the uartsbee, the following inputs :
GND
CTS
VCC
TX
RX
DTR

I've connected GND to GND, DTR to DTR, TXD to TX, RXD to RX
I guess VCC goes on VDD (but not sure) and I don't where to connect CTS (and what it is).

Help would great.

Thanks for reading !

putskiz

Finally got a response from Itead engineer, if it's ever helping for someone :

"First of all, your connection isn't quite right, you should connect them like this: TX->RXD; RX->TXD.

And you need to choose the "arduino duemilanove w/atmega328" as your board type."

And it's working now !

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy