Go Down

Topic: Level Converters on microSD cards (Read 2863 times) previous topic - next topic

Zeph

Ashley, try re-reading the same 144 bytes (non-block crossing, 108-120 us), alternating between the hardware.

From what you are saying, you are getting consistent but different speeds when reading (copying) from RAM cache to your RAM buffer, depending on the electrical connection between the SD card and Arduino - which should not matter at all since the SPI bus is not used (and which actually shouldn't matter even if it was given the synchronous SPI bus, but that's another matter).

Does that happen even re-reading the same bytes?

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy